Black plate (7,1)
Cadillac ATS Owner Manual - 2013 - crc - 6/5/12
Keys, Doors, and Windows
2-7
2. Wait for 10 minutes until the DIC
displays PRESS ENGINE
START BUTTON TO LEARN
and then press the START/
STOP button.
The DIC display will again show
REMOTE LEARN PENDING,
PLEASE WAIT.
3. Repeat Step 2 two additional
times. After the third time all
previously known transmitters
will no longer work with the
vehicle. Remaining transmitters
can be relearned during the next
steps.
The DIC display should now
show READY FOR
REMOTE # 1.
4. Place the new transmitter in the
transmitter pocket. The center
console storage area will need
to be opened to access the
transmitter pocket.
5. Press the START/STOP button.
When the transmitter is learned,
the DIC display will show that it
is ready to program the next
transmitter.
6. Remove the transmitter from the
transmitter pocket and press
K
or
Q
on the transmitter.
To program additional
transmitters, repeat Steps 4
–
6.
When all additional transmitters
are programmed, press and hold
the START/STOP button for
approximately 12 seconds to exit
programming mode.
Starting the Vehicle with a Low
Transmitter Battery
If the transmitter battery is weak or if
there is interference with the signal,
the DIC may display a message
when you try to start the vehicle.
See
Key and Lock Messages on
page 5
‑
34
.
To start the vehicle:
1. Open the center console storage
area and the storage tray.
