TR-MAN-4500-A
Operator's Manual - 4000M 4500M
Page 16 of 46
Application Pattern
There are a number of hose drag patterns that can be used during your application.
Cadman Power Equipment Limited
has found the zigzag pattern to be one of the
best methods. Although we recommend this method, you are not limited to using it.
Follow the instructions below if you are going to use the zigzag method.
img-00035.gif
1.
Using a zigzag pattern cover the first
half of your section while working away
from the reel.
img-00036.gif
2.
When you have completed the first half,
drive along the outside to the second
half.
img-00037.gif
3.
Cover the second half in a similar
fashion, using a zigzag pattern and
working away from the reel.
img-00038.gif
4.
Finish covering the entire section. Signal
the pump operator when you are
finished applying.
OPERATOR NOTE
Where field conditions
permit, always attempt
to pull the hose either
up or down sloping
terrain instead of
operating across a side
hill.
Always turn away from
the reel. Failure to do
this could cause you to
get “trapped” by the
drag hose.
Be aware of obstacles in
the field. Proper
application planning
should take into
consideration any
obstacles that could
hinder your application.
Keeping your
Cadman
Hard Hose Drag Reel
clean will dramatically
prolong its life.
Cleaning of the hose, as
well as cleaning the
exterior of the
Hard
Hose Drag Reel
is
highly recommended
after each use.