Care and Maintenance
74
©2019 CAE 905K560252 v1.0
CAE
Luna
Breakdown
To ensure your simulator remains in good working condition, follow the CAE breakdown procedures
below. These procedures take approximately 20 minutes
Step 1: Clean the Manikin
To clean the simulator, use a soft cloth and warm water to wipe off any moulage materials on the
manikin’s skin.
Step 2: Remove Excess Fluids
If you used simulated blood, we recommend flushing the tubes using a syringe filled with clear
distilled water.
To remove IV fluid:
a. Ensure stopcock lever is turned towards the syringe and opened to the
bag.
b. Fill a 3 mL syringe with 24 gauge needle with distilled water.
c. Insert syringe into each of the IV ports (scalp site, radial site, antecubital
site and foot) to flush fluids.
d. Disconnect the syringe and fill it with air.
e. Insert syringe into each port and flush with 3 mL of air. Repeat until air
exits the IV drain tubing.
f. Turn stopcock lever towards the red colored bag.
Break down the Luna Simulator
1
Clean the Manikin
2
Remove Excess Fluids
3
Power Off the Instructor Tablet
4
Power Off the Manikin
