FAST-PS-M – User’s Manual
29
Figure 14
: AC Power Line input socket
AC Source requirement
The FAST-PS-M power supplies are designed for universal AC input range since
it can operate with voltage from 100V to 240V and input frequency ranging from 47
Hz to 63 Hz. Installation Category shall be
CAT II
so maximum impulse voltage on
the network mains must be below 2500 V.
AC Input Cord
All the FAST-PS power supplies are directly shipped with the corresponding
power cord (suitable for the destination country of the purchase). Power supply side
connector is a standard IEC C13 plug. Current rating for the connector is 10A. Wire
size for detachable power supply cord, not longer than 2 m, shall be at least 0.75 mm
2
.
Wire size for fix installation shall be at least 1.5 mm
2
.
There is a potential shock hazard if the power supply chassis
is not connected to an electrical safety ground via the safety
ground in the AC input connector!
Turn off the AC input power before making or changing any
rear panel connection, Ensure that all connections are
securely tightened before applying power. There is a
potential shock hazard when using a power supply with a
rated output greater than 60 V
Wire selection
Two factors must be considered for the selection of the wires:
•
Current carrying capacity -> Cross section area
WARNING
WARNING
