Quattro Technical Information Manual
44
Connecting using the USB port
USB Communication Setup
Warning:
If your PC is running a Windows version older than Windows 10, in order to correctly
operate with the reader, you need to install the
Gadget Serial USB driver
. You can download it
for Windows based systems from the
Downloads
section or from the
Software and Firmware download area
1.
Plug an USB cable (mini USB) into your computer and connect the other end of the USB cable to the
reader.
2.
Connect the Quattro to the power supply, the power LED will turn on, wait about 30 seconds until you
hear a beep, wait 10 seconds again and the reader is ready to work with the EASY2READ profile active.
3.
In your PC, go to
Control Panel
→
Hardware and Sound
→
Devices and Printers.
After having installed
the driver (if your PC is running a Windows version older than Windows 10, otherwise the installation
of the driver is not necessary), the reader is detected by the PC as an
ELMO GMAS
(Gadget Serial)
device. Look at the COM port number (COM5 in this example):
4.
Connect the antenna cable to Ant-0 (see §
