NGPS – User’s Manual
45
MASTER SLAVE(S) CONFIGURATION
1.
Per each NGPS use the local control mode (see
Section 1.3.2
Chapter
) and select “Advanced”:
2.
In the “Advanced” window, select “Parallel”;
3.
The NGPS with the earth fuse has to be selected as “Master” and the
OFF/ON selection on “ON” and then press “Return” on the right side:
4.
The other NGPSs have to be selected as “Slave” and the OFF/ON
selection on “ON” and then press “Return”:
5.
Perform a power cycle on both modules (main switch OFF, main switch
ON).
The system is now ready to be used as if it was a single module,
controlling the MASTER only (so for remote control connect an Ethernet
cable from PC to MASTER only, for more information please check the
Remote Control Manual
).
