NGPS – User’s Manual
50
Control Page
The
Control Page
is reachable by selecting the corresponding rectangle from the
Menu Page
.
The
Control Page
gives access to the main settings of the NGPS power supply
unit. An example of a
Control Page
visualization is shown in
Figure 23: Control Page
From this screen it is possible to turn the power supply unit ON and OFF and to
set the output current or voltage (C.C. or C.V., respectively).
Actual values of output current and output voltage (readbacks) are also shown
at the bottom line of the display.
Config Page
The
Config Page
is reachable by selecting the corresponding rectangle from the
Menu Page
.
This page allows the user to set the control mode of the power supply (i.e. LOCAL
or REMOTE), to select the regulation mode (i.e. C.C. or C.V.) and to set the ethernet
(NORM) or analog (AIN) control, while at the bottom the installed firmware version is
shown (FW Version).
An example of a
Config Page
visualization is shown in
Figure 24: Config Page
