Document type:
Title:
Revision date:
Revision:
User's Manual (MUT)
Mod. SY2527, Universal Multichannel Power Supply System
27/11/2000
0
NPO:
Filename:
Number of pages:
Page:
00103/97:2527y.MUTx/00
SY2527USERMANUAL_REV0.DOC
84
38
Double-click on the Network icon in the Control Panel. Double-click on the
TCP/IP
line in
the network dialog box then select
Specify an IP address
.
If this has already been selected, the computer's IP address is set and nothing more
needs to be done. Cancel out of the TCP/IP and network dialog boxes and close the
control panel. However if the address has not already been selected, fill in the
computer's IP address and Net Mask.
6.2.3
Verifying connection
The network connection between the SY 2527 system and the host PC can be verified
using the "ping" command, available on Windows 9x/NT with TCP/IP protocol installed.
In order to check the network connection start MS-DOS prompt and type:
ping < SY 2527 IP address >
where < SY 2527 IP address > is the IP address assigned to the SY 2527 system. The
dialog box below illustrates the result of a successful "ping " with the Ethernet connection
shown established.
Fig. 6.2 - The result of a successful "ping" to the SY 2527 system
The ping command has sent a message to the SY 2527 system and waited for a
response. If the request is timed out the network connection is not working properly.
