15
1
2
3
4
x4
(x2)
Secure using two pairs
of formed brackets.
Repeat on the other
side of the chassis.
For further adjustment,
using the most appropriate
length Hexagonal socket
supplied, fully extend
levelling feet up to
required distance by hand.
Ensure product is level
and aligning with cabinetry.
Hexagonal
socket
The top mounting
brackets will only
bend upwards a
maximum of 10 mm.
Before refitting the
drawer, ensure
the hoses are not
twisted and the
latches at the rear
of each drawer
runner are facing
forward.
Lift or rotate counterclockwise the
drawer back onto the drawer runners
on either side.
Slip your finger under the slide and pull
the release tabs forward 4” (100mm)
on both sides. Ensure the tabs are fully
pulled forward and click into place.
Release tab
4” (100mm)
Installation Instructions
OPTION B - ALTERNATE METHOD (CONTINUED)
B3
SECURE TO THE SIDE CABINETRY - OPTION
SECURE TO THE ABOVE CABINETRY - OPTION
B4
REFIT THE DRAWER ONTO THE RUNNERS
Summary of Contents for CDD420P2TS1
Page 22: ...22 Notes...
Page 23: ...23 Notes...
Page 24: ...24 Printed in Thailand 31 4000257 Rev 0 11 21 GEA 518862...
