Cafe CHS90XM, Owner'S Manual

49-2001001   Rev. 1

33

Oven Light (Cont.)

CARE AND 

CLEANING:

2YHQ

/LJKW

2YHQ

'RRUV

Lift-Off Lower Oven Door

The door is very heavy. Be careful when removing and 
lifting the door.

Do not lift the door by the handle. 

For models with oven camera, the camera 
harness must be removed before removing 
the door. Open the warming drawer 
and disconnect the camera harness by 
unhooking the connector that is snapped 
into the front frame bracket before door removal.

To remove the door:

1. Fully open the door.

2. Pull the hinge locks down toward the door frame,

to the unlocked position. A tool, such as a small
flat-blade screwdriver, may be required.

3. Firmly grasp both sides of the door at the top.

4. Close door to the door removal position. The door

should be open approximately 3" with no obstruction
above the door.

5. Lift door up and out until both hinge arms are clear of

the slots.

To replace the door:

1. Firmly grasp both sides of the door at the top.

2. Starting on the left side, with the door at the same

angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.

3. Fully open the door. If the door will not fully open, the

indentation is not seated correctly in the bottom edge
of the slot.

4. Push the hinge locks up against the front frame of the

oven cavity, to the locked position.

5. Close the oven door.

Removal position

Oven Doors

Hinge lock

Slot

Pull hinge locks down to unlock

Push hinge locks up to lock

Hinge 

lock

Hinge 

arm

Indentation

Bottom 

edge of 

slot

Hinge arm

Oven Light Replacement (on some models)

The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped wire. Remove 
the oven door, if desired, to reach the cover easily. See the Lift-Off Oven Door section for detailed oven door removal 
instructions.

Replacing the Light Bulb:

1. Disconnect electrical power to the range.

2. Hold the glass cover stable, so it doesn’t fall when

released.

3. Slide near the indent of the cover holder until the

cover is released. 

Do not remove any screws to

release the glass cover.

4. Replace bulb with a 40-watt household appliance

bulb. 

Do not touch hot bulb with hand or wet

cloth. Only remove bulb when it is cool.

5. Hold glass cover stable over new bulb.

6. Pull the wire cover holder near the indent until the

indent in the
wire cover
holder is located
in the indent of
the glass cover.

7. Connect

electrical power
to range.

Wire cover holder

Indent

Glass cover 
(on self clean 
model only)