Cafe CVW9301, Owner'S Manual & Installation Instructions

49-2000061

11

INST

ALLA

TION PREP

ARA
TION

DECORATIVE DUCT COVERS

A decorative duct cover is available to fit both 

model widths. The duct cover conceals the 

ductwork running from the top of the hood to the 

ceiling or soffit. The duct cover will fit 8 ft. to 10 ft. 

ceiling heights. See page 13 for details.

This Hood Must Use 7” Round Duct. 

It Can Transition To 3-1/4” x 12” Duct.

Do NOT use flexible plastic ducting.

NOTE:

 Any home ventilation system, such as 

a ventilation hood, may interrupt the proper 

flow of combustion air and exhaust required by 

fireplaces, gas furnaces, gas water heaters and 

other naturally vented systems. To minimize 

the chance of interruption of such naturally 

vented systems, follow the heating equipment 

manufacturer’s guidelines and safety standards 

such as those published by NFPA and ASHRAE. 

When applicable, install any makeup (replacement) 

air system in accordance with local building code 

requirements. Visit 

cafeappliances.com

 for 

available makeup air solutions.

Using a smaller diameter duct size 

will reduce performance.

Installation Preparation

POWER SUPPLY

IMPORTANT – (Please read carefully)

WARNING

FOR PERSONAL SAFETY, THIS APPLIANCE 

MUST BE PROPERLY GROUNDED.
Remove house fuse or open circuit breaker before 

beginning installation.
Do not use an extension cord or adapter plug with 

this appliance. Follow National Electrical Codes or 

prevailing local codes and ordinances.

Electrical supply

These vent hoods must be supplied with 120V, 

60Hz, and connected to an individual, properly 

grounded branch circuit, and protected by a 15 or 

20 amp circuit breaker or time delay fuse.
• Wiring must be 2 wire with ground.
•  If the electrical supply does not meet the above 

requirements, call a licensed electrician before 

proceeding.

•  Route house wiring as close to the installation 

location as possible in the ceiling or wall. 

•  Connect the wiring to the house wiring in 

accordance with local codes.

Grounding instructions

The grounding conductor must be connected to 

a ground metal, permanent wiring system, or an 

equipment-grounding terminal or lead on the hood.

WARNING

 The improper connection of the 

equipment-grounding conductor can result in a risk 

of electric shock. Check with a qualified electrician 

or service representative if you are in doubt whether 

the appliance is properly grounded.