Cafe CVW9301, Owner'S Manual & Installation Instructions

18

49-2000061

INST

ALLA

TION INSTRUCTIONS

Installation Instructions

7

INSTALL MOTOR

•  Align and engage the 

slots in the blower 

assembly to the 3 

hooks at the rear of the 

exhaust opening.

•  Rotate motor upwards 

until it aligns with the 

attachment screw 

location.

•  Secure the motor to 

attachment bracket 

at the front of the 

opening with washer 

and screw provided.

•  Plug the motor connector into the 

mating hood connector. Seethe 

illustration for the hood 

connector location. Touch 

the hood to locate and make the 

connection.

IMPORTANT:

 Hold the connector 

so the two square corner terminals 

are at the top as you position the 

connector to plug it in.

9

INSTALL DUCT COVERS

To install the 12” duct cover alone:
•  Place the 12” section of the decorative duct cover 

on top of the hood.

•  Secure the cover on the top of the hood with 4 

screws provided.

To install the 2-piece duct cover:

•  Place the 2-piece duct cover on the top of the hood.
•  Secure the bottom cover to the top of the hood 

with 4 screws provided. See illustration, page 16.

•  Extend the inside section upwards to meet the 

ceiling and ceiling bracket

•  Secure the duct cover to the bracket with the 2 

small Phillips screws provided.

10

INSTALL FILTER SUPPORT

•  Tip filter support into the rear of the hood.
•  Insert support tabs into the slots at the rear of the 

hood.

•  Secure the support to the hood with screws as 

shown.

8

CONNECT ELECTRICAL

Verify that power is turned off at the source.

WARNING

 If house wiring is not 2-wire with 

a ground wire, a ground must be provided by the 

installer. When house wiring is aluminum, be sure 

to use UL approved anti-oxidant compound and 

aluminum-to-copper connectors.

•  Use wire nuts to connect incoming ground to 

green, white to white, and black to black.

•  Push wires into junction box and replace cover. 

Be sure wires are not pinched.

Motor Attachment 

Bracket

Motor Hooks

Ground

A

   Remove 

Junction 

Box Cover

B

  Check that White, Black 

and Green Hood Wires 

are Threaded thru Small 

Hole in Bracket.

D

  Use UL Listed Wire Nuts

C

  Insert Power 

Conduit thru 

Strain Relief 

and Tighten

Black

White

Insert Tabs into Slots

Install 2 Screws