26
The wheels on your FS200 Vario are subjected to strong loads. After the first
100 to 300 km of use, a Ca Go dealer should check the wheels and true them
if required. You should continue to check the wheels at regular intervals even
thereafter.
Tyres and tyre pressure
The recommended tyre pressure is indicated in bar and PSI on the side wall
of the tyre or on a label on the rim. Please always ride with the specified tyre
pressure – depending on rider’s weight and cargo.
• Front tyre pressure: 2.0 to 4.0 bar
• Rear tyre pressure: 1.5 to 3.0 bar
Hub bearings
The hub bearings need to be checked from time to time. To do this, lift the
wheel off the ground and rotate it by hand.
If the wheel keeps running only for a short time and non-concentrically,
and if it stops suddenly, the bearing may be defective.
To check if the hub bearing is loose, pull the wheel in the rear drop-out or fork
to the right and left. While doing so, have a second person hold the handlebar.
If you can move the wheel slightly to the side in the bearing or if the wheel is
hard to turn, the hub bearings need to be serviced by a Ca Go dealer.
Wheels and tyres
Summary of Contents for FS200 Vario
Page 1: ...EN FS200 Vario User manual...
Page 55: ......
