Personal Ambulatory Oxygen System
Provider Technical Manual
73
2) Position the product tank with the 2 hose barbs facing in the direction of the ATF. Refer to Figure 46.
Figure 46: Product tank and hose barbs
3) Install the securing arm over the product tank, and locate the screw hole on the back case cover for the old product tank
securing arm that was to the right(top side of compressor). See Figure 47.
Figure 47: Install securing arms
4) Locate the Product Tube - remove black ATF outlet barb cap, and attach the Product Tube Assy to the ATF output barb,
secure with a cable tie. Attach the other end of the Product Tube to the Bottom port on the Product Tank.
Install securing arm
and install two screws
