Introduction
cairn
Congratulations, you own a unique device!
Cairn & Ezo staff wish you will spend a pleasant time using
The
CD Player is easy to use. This startup guide gives you the necessary elements to set it up in
a few seconds. We recommend you to refer to the owner’s manual to take full advantage of all the
features. You will also discover how to build your system around
FOG3
FOG3.
FOG 3
CE Declaration of conformity
FCC notice
Cairn declare that this product is in conformance with the Low Voltage Directive 73/23/EEC.
The conformity of the designated product with the provisions of directive number 73/23/EEC (LVD) is
proved by full compliance with the following standards:
Standard EN60065 (1993) test type: Marking, ionizing, heating under normal conditions, shock hazards
under normal operating instructions, insulation requirements, fault conditions, mechanical strength,
parts connected to the mains supply, components, terminal cords, electrical connections and
mechanical fixings.
The conformity of the designated product with the provisions of directive number 89/336/EEC (EMC) is
proved by full compliance with the following standards:
Standard number
Date of issue
Test type
EN55013
2001
Conducted emissions
EN55013
2001
Absorbed emissions
EN60555-2
1994
Hamonics
EN60555-3
1994
Voltage fluctuations
EN55020
2002
Immunity
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designated to provide reasonable protection
Release 1.04
-Before removing mains supply, take care to turn the device in sleep mode because overvoltage
could damage it.
-Do not use extension lead between the outlet and the device.
-Unauthorised opening of the device cancel the manufacturer warranty.
-Do not cover the air cooling
-Put the device far from
source.
-Do not introduce anything into the device.
DO NOT REMOVE THE COVER, SHOCK HAZARD.
THE DEVICE IS DELIVERED WITH A POWER CORD MATCHING WITH THE ELECTRICAL STANDARDS OF THE
COUNTRY OF DESTINATION.
THE DEVICE
NOT CONTAIN ANY COMPONENT THE USER CAN REPARE HIMSELF.
IN CASE OF TROUBLESHOOTING, PLEASE CONTACT YOUR REGISTERED DEALER.
USE THE SAME TYPE OF FUSE AS THE ORIGINAL.
DO NOT EXPOSE TO MOISTURE..
Maintenance
WARNING
grid.
warmth
DOES
First, unplug your product from the AC plug. A chamois leather slightly moistened with water is sufficient
for cleaning your CD player. Do not use cleaning agents containing moistened airits, ammoniac or
abrasives. Do not try to clean the inside of the product.
Care considerations
