Checking the rear wheel bearings
CAKE recommends an authorized CAKE workshop perform this service task.
Tool: Allen key 6mm, wrench 22mm, 24mm, Torx 20, 25, 30.
Wanted state: When rotated, the bearings should slide smoothly
1. Remove the battery.
2. Remove the control box lid. Unscrew the 4 screws. Use Torx 25.
3. Disconnect the motor sensor cable.
4. Disconnect the motor cables by unscrewing the blue, green, and yellow
cables. Use an 8mm wrench.
5. On the swing arm, unscrew the 2 cable holder screws. Use Torx 25.
6. On the swingarm bridge, unscrew the 2 fender screws. Use Torx 30.
7. Unscrew the 4 fender screws. Use Torx 20. Remove the rear fender.
8. Loosen the wheel axle nut. Use wrench 22mm and 24mm.
9. Unscrew the 2 screws holding the motor bracket. Use Allen key 6mm.
10. Carefully pull out the wheel.
11. On both sides of the wheel, rotate the bearings. If the bearings do not run
smoothly, there may be an issue with the bearings and/or the hub.
Contact an authorized CAKE workshop. Otherwise, continue below.
12. Mount the wheel. Tighten the wheel axle nut to 50Nm. Use wrench 22mm
and 24mm.
13. Mount the motor bracket. Tighten the 2 motor bracket screws to 20 Nm.
Use Allen key 6mm.
14. Tighten the wheel axle nut. Use wrench 22mm and 24 mm.
15. Mount the rear fender. Tighten the 4 fender screws to 10Nm. Use Torx 20.
16. Use an 8mm wrench to connect the motor cables according to the following:
I. Blue --> U
II. Green --> V
III. Yellow --> W
17. Connect the motor sensor cable.
18. Attach the control box lid.
19. On the swing arm bridge, tighten the 2 fender screws. Use Torx 30.
20. On the swing arm, tighten the 2 cable holder screws. Use Torx 25.
21. Attach the battery.
50
Summary of Contents for Makka
Page 1: ...Makka Manual Makka Manual...
Page 62: ......
