001-0003-822 Rev 1
Page 29 of 48
To allow the PC LAN connection to access the modem’s web interface, the TCP/IP Properties will
need an IP address entered manually. This is because the DHCP server is disabled. Right click on
the Local LAN connection icon and select “Properties”. Refer to Figure 7.5 below.
Figure 7.5 TCP/IP Properties
If PPPoE is disabled and the DHCP server is re-established in the modem, remember to select
“Obtain an IP address automatically” at this screen. This will allow the modem to set the IP address
of the LAN connection.
Remote Administration
Remote Configure:
Selecting Enable will allow remote access to the modem’s configuration screens through the cellular
network connection. Selecting Disable will shut off the ability to remotely access the modem’s
configuration screens.
Incoming Port:
This sets the port number used to remotely configure the modem. The default port is set to 8080.
Admin Password:
This sets the password required for remote configuration accessibility.
Confirm Password:
Re-type the Admin Password to confirm the correct spelling.
