2008 Barbecue Grill and Cart Owner’s Manual
Page 25
LTR20081038, Rev. B
Appendix
All Cal Heat grills are manufactured as standard liquid propane (LP) grills and can be converted to burn natural gas
(NG). There are two steps required to convert a grill from LP to NG.
You must perform both steps.
Step 1: Switching the regulator behind the grill
Step 2: Changing the burner orifices
You will need some or all of the fittings (depending on
the size of the grill or cart) contained in the conversion
kit provided with the grill. The conversion kit contains
orifices to convert five main burners, two small rear
infrared burners, one large infrared burner, and two
side burners. You will not need all of the parts in the
kit.
Before you begin, make certain the LP gas source has
been disconnected from the grill. If you have a cart,
you do not need to remove the grill from the cart.
To gain access to the NG regulator:
For grills, tilt the grill forward.
•
For barbecue carts, remove the back cover.
•
Step 1: Switching the regulator behind the grill
The regulator in the image below has been removed from a grill to illustrate this
procedure.
Remove the LP gas line.
1.
Remove the cap fitting from the end of the NG gas regulator.
2.
Place the cap fitting over the LP gas inlet.
3.
Insert the 3/4” flared in the NG gas regulator.
4.
Converting from LP to NG
WARNING! You must have an authorized service technician perform this procedure . If these
instructions are not followed exactly, a fire or explosion may result causing property damage,
personal injury or loss of life . Lloyd’s Material Supply (L .M .S .) will not be held responsible for
an improperly converted gas grill .
You will need:
13mm open end
•
wrench
3/4” flared fitting
•
Pipe compound
•