Page 26
2008 Barbecue Grill and Cart Owner’s Manual
LTR20081038, Rev. B
Appendix
Step 2: Changing the burner orifices
Replace the infrared burner orifices
1 .
Using a 13mm wrench, remove the orifice for the infrared burner.
a.
Apply pipe compound to the fitting threads where you will place the new
b.
orifice.
Screw on the correct orifice for your grill until it is finger tight.
c.
Tighten the orifice with the 13mm wrench.
d.
If you have dual infrared burners, repeat the previous steps for the second
e.
burner.
Replace the back cover.
f.
Replace the side burner orifices
2 .
Remove the grate, burner cap and burner diffuser from the side burner.
a.
Using a 7mm wrench, remove the orifice for the burner.
b.
Apply a small amount of pipe compound to the orifice threads.
c.
Screw in the orifice until it is finger tight.
d.
Tighten the orifice with the 7mm wrench.
e.
If you have dual side burners, repeat the previous steps for the second
f.
burner.
Replace the main burner orifices
3 .
Remove the grates, flame tamers, and drip tray from the grill.
a.
Remove the cotter pins from the end of the burners. The cotter pins are
b.
accessible from underneath the grill in the back in the accessory cabinet.
Carefully remove the burner.
c.
Using a 6mm socket or nut driver, remove the orifice for the burner.
d.
Apply a small amount of pipe compound to the orifice threads.
e.
Screw in the orifice until it is finger tight.
f.
Tighten the orifice with the 6mm wrench.
g.
Repeat the above steps for the remaining burners.
h.
Replace the burners, cotter pins, flame tamers, drip tray, and grates.
i.
Apply the sticker
4 .
After conversion has been completed, apply the enclosed sticker to the rating plate. The sticker reads “This unit has
been converted from LP to NG.”
BTU Ratings: This is provided for information only .
Main burners
15,000 BTU
1.9mm
Infrared burner CF 3 – 5
9,000 BTU
#54 DMS
Infrared burner CF 4
12,000 BTU
#52 DMS
Side burner
13,000 BTU
#50 DMS
You will need:
6mm socket or nut
•
driver
Two to five 1.9mm
•
orifices (depending on
your grill
Pipe compound
•
You will need:
13mm open end
•
wrench
One #50 orifice (for
•
single infrared burner)
Two #54 orifices (for
•
dual infrared burners)
Pipe compound
•
You will need:
7mm wrench, socket,
•
or nut driver
One or two 1.75mm
•
orifices (depending on
your side burner)
Pipe compound
•
