S-700 Assembly Instructions
The following instructions will guide you through the assembly of the S-700 Sauna.
1.
Assemble the benches. Screw the legs into the underside cross-support of the benches. After assembling
the benches, place the benches on the wooden flooring of the sauna (
A
).
2.
Place the heater bottom support on the front left corner and place the heater on top of the heater support.
3.
Place the wall panels against the flooring and attach the panels (with the provided screws) to the floor-
ing (
B
).
4.
Take the rounded corner pieces and position them in each corner (
C
).
5.
Screw each section together using the toe-in method (
E
). Repeat these steps, as necessary, to complete
the wall assembly.
6.
Place roof top panel onto the wall panel assembly. Place the 1”x2” roof supports, inside the sauna, up
against the roof top (
D
).
7.
Attach the two door trim peices with the provided screws (
F
).
8.
Place the outside trim piece(s) flush with top of the roof.
9.
Place the heater bracket around the heater and secure it in place.
Figure 16A
. S-800 Extreme Sauna Step 1 through Step 3
Page 24
Owner’s Manual
Owner’s Manual
Assembly
