8600 Series
Installation Instruction
26 of 40
CAL-ROYAL PRODUCTS, INC.
6605 Flotilla St. Commerce CA 90040
Tel: (323) 888-6601; Fax: (323) 888-6699
Email: sales@cal-royal.com; Website: www.calroyal.com
Section # 9.0 - Wiring Connections
9.1 On/Off/Hold Open
Switch
3 position switch offers easy selection for 3 modes of operation:
Hold Open
– The operator will hold the door, in the fully open position for an unlimited amount of
time. The motor will not overhead or fail causing the door to close.
Off/Manual
–
The door is free to open by hand and will fully close with spring power. This function does
not switch off the power, however motion sensors / push plates are still active but are ignored.
Automatic
– Motion sensors / push plates are active and will activate the operator to open the door
automatically should they be triggered.
9.3 ‘Act2’ – Activation 2
Connected to activation switch such as motion sensor or push plate. Only active after Act1 is triggered.
Or when the door is closing and before reaching the latch position.
9.2 ‘Act1’ – Activation 1
Connected to activation switch such as motion sensor or push plate. When activated this signal always opens the door.
24v
12v
GN
D
NC
NO
CO
M
24v
12v
NG
N
DC
NO
CO
M
CAL-ROYAL
CAL-ROYAL
Selector
