STEP 2: INSTALL DEVICE & CUT DEVICE IF REQUIRED
2A. INSTALL DEVICE
(1) Take off head cover and put device horizontally at the door. Fix screws (B1) on chassis but DO NOT tighten them at this step.
(2) Install bracket with screw (B2). Be sure to remain device being horizontal and then tighten all screws.
(3) Install end cap & Install head cover after STEP 9.
*
for
"FIRE RATED":
please drill
r/J
¾"
(9.6mm) hole for sex bolt (E).
*
for
"NON-"FIRE-RATED":
please use screw (B2) directly.
�e,
I
§
(
....
-
28. CUT DEVICE IF REQUIRED
(1) Device length A must be at least 1½" (38mm) s orter than B.
Measure from the edge of head cover
(not from the edge of latch)
(2) If
required,
cut length C, so A is at least 1½"(38mm)
shorter than B.
Ensure no gap between
sliding cover and push rail end.
NOTE : the minimum length of the sliding cover must be
1"(25.4mm) or longer than length "C".
CAL•ROYAL PRODUCTS, INC. USA I VERSION 2022
4
LEVEL
\!V
I
I
D
Measure from strike top/
(3)
Standard Door Stop is %"(15.9mm). lnstall½"(3mm)
strike shim if required.
strike
EDG-404
5
-01/23-
4
of
8
