Cal-Royal CRCODE-202, Instruction And Programming Manual

Mark and Drill Door

1. Attach TEMPLATE onto door and verify 
    backset and latchbolt center, before 
    marking and drilling holes on the door.

2. Drill holes on the door.

    *Drilling a hole from both sides is 
     recommended to avoid splintering wood doors.

2.1 Drill 2 

1

/

8

” diameter thru holes.

2.2 Cut notch horizontally.

2.3 Drill two two 3/8” holes on top, per TEMPLATE.

2.4 Drill two 3/8” thru holes, on top and bottom of 
      the bore hole vertically.

2.5 Drill 1” hole on the edge of the door. Chisel a 

UDEEHW´GHHSWRDOORZODWFKIDFHÀXVK¿W

      with door edge. Mortise for latchbolt front 
      1 

1

/

8

” width x 2 

1

/

4

” height x 5/32” deep. 

2.6 Drill Pilot hole for latchbolt screws 7/64”.

3. Prepare and install strike.

3.1 Close door and mark a horizontal line from the 
      center of the template to the frame of the door.

3.2 Cut a rabbet of 1/8” deep to allow strike to 

ÀXVKZLWKMDPE

3.3 Align hole of the strike with vertical line. 
      Tighten strike plate using two screws provided.

Drill the latch hole 

in the middle of the 

door width

38” from 

WKHÀRRU

4

6605 Flotilla St., Commerce, CA 90040

Tel (323) 888-6601 Fax (323) 888-6699

www.cal-royal.com