Inside Lock Installation
Install Strike Plate
Check & Adjust
3
1
2
1. Place Inside Lock onto the door.
3. Fasten with 8-32 X
3
/
8
” screws.
2. Push lever onto the hub until it clicks.
1. Align strike plate with rabbet.
2. Fasten strike plate with 2 screws.
1. Enter factory set code and make sure that the latchbolt
retracts and the lever handle turns smoothly.
2. Check the operation of the inside lever handle.
3. Insert the key to check if the latchbolt retracts.
4. Close the door and make sure it closes without getting
stuck. (Remove the key before closing the door)
5. Enter the code or use the key to open the door.
6. If there is no binding of the latch or handles, the lock is
FRUUHFWO\¿WWHG2WKHUZLVHORRVHQWKH¿[LQJEROWVDQG
reposition the strike plate slightly until the correct
position is found. Re-tighten the bolts.
After entering the correct code, check the
lever if it is correctly installed by pushing
the lever down. If the latch retracts, push
the lever again without entering a code.
If it goes to breakaway mode, the lever
is installed correctly; if the latch retracts,
refer to
Check Spindle Timing
on
page 5 and adjust the timing.
9
6605 Flotilla St., Commerce, CA 90040
Tel (323) 888-6601 Fax (323) 888-6699
www.cal-royal.com
