8
PL7100 / RS2100
6.4 CODE Unlocking
Wake-up touchpad, enter CODE followed by #
6.5 VARICODE Unlocking
• VARICODE is a time-specific temporary code that can be
generated in the App. VARICODE can be generated in the
App anywhere; no need to be in front of the Lock.
• VARICODE can be obtained in the App:
In the Clients page, press the “+” on the top-right corner, and select
Type as VARICODE to see the UI. Once generated, send the
VARICODE to the users.
• For VARICODE Unlocking:
Wake-up keypad, enter #, enter VARICODE
7.
Unlocking by RFID Card / Key Fob
Tap the card/key fob in front of the sensor/touchpad, and wait until the
LED flashes and you hear a sequence of beeps.
8.
Low Battery Warning
There are two indicators when the batteries are running low:
• When successfully unlocked, you will hear 3 beeps then 5 beeps for
low battery warning.
• If the batteries are too low, it will not unlock even after successful
authentication using a registered RFID/Key Fob/Phone or correct
CODE, and you will hear 3 beeps then 10 beeps as warning.
**Both indicators will only stop once the batteries are replaced with new ones.
