9
PL7100 / RS2100
Events
Beeps
LED
Setup Button Pressed
2 short beeps
Green flash 1x
Exit Setup Mode
2 short and 1 long beeps
Green flash 1x
During Setup Mode
-
Red light ON
Pairing Success
4 beeps ascending tone
Green flash 1x
Pairing Fail
1 long and 4 short beeps,
the long beep tone is higher
Red flash 1x
9.
Lock-out
After 3 consecutive unsuccessful unlocking attempts, the Lock will be
non-responsive for 1 minute.
10. Reset to Factory Default
To reset to factory default, follow these steps:
1. Remove battery cover and take one battery out.
2. Press and hold setup button and replace the battery.
3. Wait until you hear 4 beeps and then release the setup button.
All previous created users and Admin will be deleted.
4. Replace the battery cover.
11. Events, Beeps and LED
