2017 Fitness Spa
LTR20171005, Rev. D
Cleaning and Maintenance
www.calspas.com
45
Cleaning Your Spa
Spa Cover and Pillows
Due to the constant punishment your spa cover and pillows receive, you should protect them by applying
a vinyl and leather cleaner as part of your monthly maintenance plan. Use a product that is specifically
designed to protect spa covers and pillows from chemical and ultraviolet light damage without leaving an
oily residue behind that is normally associated with common automotive vinyl protectants.
Warning:
Do not
use automotive vinyl protectants on spa covers or pillows. These products are generally
oil-based and will cause severe water clarity issues that are difficult to correct.
Spa Shell
Each time you drain your spa, before you refill it you should clean your spa shell with an all-purpose cleaner
and apply a coat of surface protectant.
Use a low detergent, non-abrasive cleaner specifically formulated to clean the spa without damaging its
acrylic finish.
Use a non-oil based surface protectant that is specifically formulated to protect the spa’s finish from the
chemicals and minerals associated with normal spa use.
Changing the UV Lamp
CAUTION: Always turn off power to the spa at the GFCI prior to
any maintenance .
Note: Periodically you should the check the light on the transformer for the UV light
system. The transformer is mounted in the spa equipment area close to the system
control box. When it is operating normally, the light will be green. When it requires
maintenance, it will be red. This usually happens when the UV lamp needs replacing.
The UV lamp is a wearable part that needs replacing about once a year.
To remove the UV lamp
1.
Disconnect power.
2.
Turn water off and open down stream of system to relieve
pressure.
3.
Cut the tie wrap that attaches the UV lamp chamber to the
spa frame.
4.
Remove the water-proof strainer (1) and unscrew the
aluminum nut (2).
5.
Pull out the lamp (4) approximately 2” from the chamber (7).
6.
While holding the lamp end, remove the lamp socket (3) from
the end now exposed.
7.
Remove the lamp from the chamber.
8.
Remove the O-ring (5) from the end of the quartz thimble (6).
9.
Remove the quartz thimble.
To reinstall the replacement UV lamp, follow these steps in reverse.
When replacement UV lamp has been installed, conduct a final
leak check:
1.
Restore power to the spa at the GFCI.
2.
Turn on the pump and let water run for five minutes to check
for leaks.
1 Water-proof strainer
2 Aluminum nut
3 Lamp socket and lead
wire
4 Germicidal UV lamp
5 Rubber O-ring
6 Quartz thimble
7 Chamber
8 Clip
9 Ballast
Summary of Contents for F-1222
