2015 Portable Spa
LTR20151001, Rev. A
Operating
Your Spa
www.calspas.com
26
Setting Dual Temperature Ranges
Selecting Heat Modes – Ready vs . Rest
Ready-in-Rest Mode
Circulation Mode
This system incorporates two temperature range settings with independent
set temperatures. The specific range can be selected on the Settings screen
and is visible on the Main Screen in the upper right corner of the display.
These ranges can be used for various reasons, with a common use being
a “ready to use” setting vs. a “vacation” setting. Each range maintains its
own set temperature as programmed by the user. This way, when a range is
chosen, the spa will heat to the set temperature associated with that range.
High Range can be set between 26.5°C and 40°C (80°F and 104°F). Low
Range can be set between 10°C and 37°C (50°F and 99°F). More specific Temp Ranges may be determined
by the Manufacturer. Freeze Protection is active in either range.
In order for the spa to heat, a pump needs to circulate water through
the heater. The pump that performs this function is known as the “heater
pump.”
The heater pump can be either a 2-speed pump (Pump 1) or a circulation
pump. If the heater pump is a 2-Speed Pump 1, Ready Mode will circulate
water every 1/2 hour, using Pump 1 Low, in order to maintain a constant
water temperature, heat as needed, and refresh the temperature display.
This is known as “polling.”
Rest Mode will only allow heating during programmed filter cycles. Since polling does not occur, the
temperature display may not show a current temperature until the heater pump has been running for a minute
or two. While Pump 1 High can be turned on and off, Pump 1 Low will run until set temperature is reached,
or 1 hour has passed.
READY/REST appears in the display if the spa is in Rest Mode and the Jets
1 Button is pressed. It is assumed that the spa is being used and will heat
to set temperature. While Pump 1 High can be turned on and off, Pump 1
Low will run until set temperature is reached, or 1 hour has passed. After 1
hour, the System will revert to Rest Mode. This mode can also be reset by
entering the Settings Menu and changing the Heat Mode.
Settings
Back
Temp Range
Heat Mode
Time of Day
Filter Cycles
Light Cycle
Invert Panel
Lock
High
Ready
Normal
Settings
Back
Temp Range
Heat Mode
Time of Day
Filter Cycles
Light Cycle
Invert Panel
Lock
High
Ready
Normal
If the spa is configured for 24HR
circulation, the heater pump generally runs
continuously. Since the heater pump is
always running, the spa will maintain set
temperature and heat as needed in Ready
Mode, without polling. In Rest Mode, the
spa will only heat to set temperature during
programmed filter times, even though the
water is being filtered constantly when in
Circulation Mode.
Set: 40°F
8:32 PM
Ozone
Filtre 1
Spa
Scènes
Paramètres
Haute Gamme
39°C
Prêt/Repos
Chauffage
Back
Filter Cycles
Back
Filter Cycle 1
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
Filter Cycle 2 NO
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
Filter Cycles
Filter Cycle 1
Starts at
6:15
AM
Runs
3
HR 0 Min
Ends at 9:15 AM
Filter Cycle 2 NO
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
Cancel
Save
Summary of Contents for Home Resort Z-524L
Page 1: ...LTR20151001 Rev A 1 14 15...
