Operating Your Spa
•
Four times to activate high speed on pumps 2 and 3
•
Five times to turn off pumps 2 and 3
Light
Press the LIGHT button to turn on the spa light and again to turn the light off.
Turbo
Press the OPTION button to turn on the turbo system. Press it once again to turn off the turbo system.
Setting the Temperature Lock
This feature allows you to lock a temperature into the system. When engaged the set temperature will blink on
and off when the TEMP button is pressed. However, you will not be able to change it until you unlock the set
temperature:
•
Press the TEMP button.
•
Press the OPTION button to unlock the set temperature.
•
Select a temperature with the TEMP button.
•
Press the OPTION button to set and lock the temperature.
Automatic Time Outs
These features will automatically turn themselves off during periods of continuous use:
•
Low speed pump
After 30 minutes
•
Optional circulation pump
After 4 hours
•
High-speed
pump
After
15
minutes
•
Optional turbo system
After 15 minutes
•
Spa
light
After
after
15
minute
Setting Filtration Cycles
Your spa will automatically filter itself twice a day. To set the filtration time, turn off the power to the spa at
the GFCI breaker. Turn the GFCI breaker back on at the time of day you would like to start the filtration cycle.
The first cycle will start after the spa is powered up. The second filtration cycle will begin twelve hours later.
The filtration cycle duration is preset to 2 hours (F2). To change the duration of the filtration time, press the
Temp pad, then press the Jets pad. Press the Temp button again to choose from 2,4,6,8, and 12 hours twice a
day (FC = Filtration Continuous).
Page 20
2005 Spa Owner's Manual
8/1/2005
Summary of Contents for LTR20051000
