Bag 3
4-40 x 1/4”
Red Button Head
Motor Plate
Graphite X-brace
Graphite
Top Plate
2-56 Steel
Ballstud - Black
Front
of
car
1 - Install the black 2-56 ballstuds [16] into the graphite top plate [17]. These steel balls thread into the graphite, no nut is needed. Be sure to start them
straight and square.
2 - Insert a red button head screw [22] through the bottom of the graphite top plate [17] so that the threads point upward. Slide two washers [8] over the
screw and then tighten with the red female ballstud [18].
3 - Install the Graphite X-brace [19] to the back of the two aluminum pods [20 & 21]. Use 4 red button head screws [22] to attach the graphite piece to the
aluminum.
4 - Attach the assembled top plate to the pod plates using 2 red button head screws [22].
Rear X-Pod
3
16
17
20
16
17
19
20
22
18
19
22
22
21
Red Aluminum
Female Ballstud
18
4-40 x 1/4”
Red Alum FH
23
Left Side Pod Plate
21
Washer
8
8
