24 —
M
achinist
c
alc™
P
ro
PaPErlESS TaPE OPEraTION
The Paperless Tape allows you to display and review the last
thirty entries of a regular math or basic dimensional math
sequence.
To access this mode after entering values, press
g =
. Then,
press
+
or
-
to scroll forward or backward through the
entries.
While in the Paperless Tape mode, the display will show
the previously entered or calculated value, along with the
sequential number of the entry (e.g., 01, 02, 03, etc.) and the
math operator (+, –, x, ÷, %) in the upper left corner of the
display.
Note:
If
=
has been used in the middle of a sequence, SUB (for
Subtotal) will display in the upper left. If
=
was the last operation
performed, the display will show TTL (Total) as the last entry.
To exit this mode, press
=
to exit and maintain the last entry
on the display. When exiting, the last entry (or TTL) will be
displayed, allowing you to continue using the last tape value
for another operation, if desired.
Note:
The Paperless Tape is cleared when you do one of the following:
-
O
is pressed twice
- upon a new calculation (new equation string is started)
- when the calculator is shut off.
Add a sequence of values and access Paperless Tape mode
to review your entries. Then, add another value to your total.
KeySTROKe
DISPLAy
1. Add a sequence of values:
O O
0.
4 i +
4.
INCH
