U
ser
'
s
G
Uide
— 37
The selected Drill Size is displayed along with its decimal Inch
equivalent. If the entered value doesn’t match a Drill Size, the next
smaller size is displayed. You can toggle through the available
sizes in increasing order with either the
D
key or the
+
key. The
-
key displays the available sizes in decreasing order. To set the
displayed Drill Size, press
O
(or any other key).
Numeric Drill Size entry
Enter a #36 Drill and toggle through the next larger available
sizes:
KeySTROKe
DISPLAy
O O
0.
1. Enter the Drill Size:
3 6 D
36
DRILL SIZe
$
0.1065
INCH
2. Display the next larger available sizes:
D
2_75
MM DRILL SIZe
$
0.1083
INCH
D
7/64
DRILL SIZe
$
0.1094
INCH
D
*
35
DRILL SIZe
$
0.1100
INCH
* Repeated presses of
D
display the next larger Drill Sizes. The
+
and
-
keys will toggle forward and backward, respectively, through all
available Drill Sizes.
Letter Drill Size entry
You can enter letter Drill Sizes by selecting an alphabet character
via Alpha Mode (
g 8
) and then storing it using the
D
key. The
desired letter can be selected by toggling through Alpha Mode
until the letter is reached or by specifying the numerical order of
the letter within the alphabet prior to entering Alpha Mode. Both
methods are shown below.
Select Drill Size E by toggling though Alpha Mode. Then, select
Drill Size G by entering the numerical order of the letter (the letter
G is 7th in the alphabet).
(cont’d)
