1. MEASUREMENT DISPLAY:
Total*
– Displays the accumulated total of all measured segments.
Side
– Displays only the last measured segment.
2. BEEP:
On*
– Beeps once after:
• a successful measurement
• a successful PC data send
– Beeps twice after:
• an unsuccessful measurement
• an unsuccessful PC data send
• an error
Error
– Beeps twice only after:
• an unsuccessful measurement
• an unsuccessful PC data send
• an error
Off
– Beep is turned off (never beeps)
3. US/EURO DISPLAY:
US*
– Displays commas and decimals in standard US format;
commas separate groups of three digits and decimals
separate whole digits from decimal digits (e.g., 1,234.00).
Euro
– Displays commas and decimals in standard European
format; commas separate whole digits from fractional
digits and decimals separate groups of three digits
(e.g., 1.234,00).
4. PC SEND DISPLAY:
Hold*
– The displayed value is not cleared after being sent to the
PC.
Clr
– The displayed value is cleared after being sent to the PC.
This setting is ignored while measuring.
The following Preferences allow you to customize your Ultra Scale Master Pro. Access the Preferences by pressing [PREFS],
located under the slide cover door. Press D-Pad up [
5
] or down [
6
] to scroll through the Preferences. Press D-Pad right [
4
] or
left [
3
] to scroll through the available settings within the selected Preference.
PREFERENCES
U
SER’S
G
UIDE
— 45
Summary of Contents for 6260
Page 1: ...USER S GUIDE Area Take Off Tool and Digitizing System Model 6260...
Page 11: ...Right Hand Configuration Shown USER S GUIDE 9...
Page 51: ......
Page 52: ......
