ProjectCalc
®
Plus MX User’s Guide — 2
Ç 8
— Percent
(%)
Memory
Ç =
(M+)
— Adds the displayed value to the semi-
permanent memory register (e.g.,
1 5 0 Ç =
).
Semi-permanent means the value is cleared when the
calculator is turned off.
r =
(M-R/C)
— Recalls memory value (e.g., if 150
has been stored in Memory, pressing
r =
will display
150).
Note:
This function displays, but does not clear, the
memory register.
r r
(M-R/C)
— Displays and clears/deletes any
value stored in the memory register.
Ç o
(Off)
— Turns calculator off and clears the
memory register.
s =
— Memory Store (replaces stored memory
value with the displayed value).
Measurement Unit Keys
m
Enters or converts to metres.
M
— Millimetres
Enters or converts to millimetres.
Ç 7
(cm)
— Centimetres
Enters or converts to centimetres. For example, to enter
50 centimetres, input
5 0 Ç 7
.
f
Enters or converts to feet as whole or decimal numbers.
Also used with the
i
and
/
keys for entering Feet-
Inch-Fraction values (e.g.,
6 f 9 i 1 / 2
).
Repeated presses during conversions swap between Feet-
Inch-Fractions and Decimal Feet.
i
Enters or converts to inches. Entry can be whole or decimal
number. Also used with the
/
key for entering fractional inch
values (e.g.,
9 i 1 / 2
). Repeated presses during
conversions swap between Fractional and Decimal Inches.
PRG8528E-G 10/23/09
Page 2
Summary of Contents for ProjectCalc Plus MX 8528
Page 23: ...10 09 PRG8528E G...
Page 24: ...C M Y CM MY CY CMY K...
