GETTING STARTED
Once assembly and setup are complete, proceed with the following steps in
order to begin measuring.
1. When placing the bars and securing the drawing, make sure that the
bars are at least 1" from the outermost measurements.
2. It is essential that the bars remain fi xed relative to the drawing’s
position. Scribe a line to mark the initial location of the bars as a
reference point should the bars shift.
3. The Puck should maintain a 45° angle within the bars while measuring.
4. Ensure that the measuring surface is fl at and smooth. Make sure there
are no folds, tears, or raised areas of the plans.
5. Make sure there are no objects between the Puck and the bars. This
includes hands, arms, pencils or pens, cups, scale rulers, etc.
6. Make sure that no air current is blowing directly into the measuring
area. Air blowing into the measuring path can result in no
measurement reading.
7. To get accurate measurements, make sure that the Puck and the bars are
close to the ambient temperature of the work environment.
8 — U
LTRA
S
CALE
M
ASTER
®
