Caldera SMt364, Use And Care Manual

14

19. HOOD CONTROL (Fan speed & Light control) 

FAN CONTROL: 

The Hood is activated from the cooktop. There is one Fan touch key

 and 

an LED is located under the Fan touch key.  Touching the Fan key (short touch) flashes the Fan 
LED for a period of 10 seconds, indicating that the Fan is in Initial Programming Mode. 
Touching one of the L, 1, 2, 3,…H level keys within the 10-second period starts the fan speed at 
the corresponding power. The last selected Fan level will be stored in memory for further recall. 
Touching “0” after selecting the fan will turn the Fan ‘off’ and maintain Programming Mode for 
5 seconds. Any subsequent touch within the 5-second Programming Mode will turn the Fan “on” 
again at the newly selected speed. Touching the Fan key while the fan is operating will re-enter 

Programming mode and enable the fan speed to be changed.  The Timer

 can then be invoked 

during Programming Mode to program a timed shut off (see paragraph 20). 

 
LIGHT CONTROL 

If there is a light bulb installed in the hood, it can also be controlled from the Fan touch key. To 
activate the light, touch and hold the Fan touch key for 1 second, if the light was ‘off’ it will be 
turned ‘on’, and if the light was ‘on’ it will be turned ‘off’. 
 
NOTE 1: Turning the light ‘on’ or ‘off’ also places the fan in Programming Mode. Meaning that, 
during the following 10 seconds after activating the light functions, touching a level key (L, 1, 2, 
3…H or Recall) will turn the fan ‘on’ to the selected level. 
 
NOTE 2: The fan and the light can be independently controlled at any time regardless of the 
status of either of them. 
 

20. TIMER DESCRIPTION & FUNCTIONS 

a. 

General: 

The timer key 

 features two seven-segment displays.  The Timer 

can be set from 0 to 99 minutes by one-minute increments.  When the Timer 
key is touched, the timer digits start with two - zeros. The last number key that 
is touched is the furthest right digit.  For example, start with '00', touch '5' with 
no more touches the timer would be on for 5 minutes.  Touch '5', then '1'; timer 
is on for 51 minutes.  Touch '5', then '1', then '0'; timer is on for 10 minutes 
(scrolling the “5” out to the left). The timer can be used for each and every 
element to set cook time, to set a fan time and as a stand-alone timer. Each can 
be set separately and run simultaneously. 

b. 

Timer display: 

The time relative to the "cook time" of any particular 

element is displayed exclusively during Programming Mode of that element. 
The time relative to the Fan time is displayed exclusively during Programming 
Mode of the Fan. The time relative to the Stand-alone Timer is displayed at all 
times except during Programming Mode of any element or of the Fan. 

c. 

Timed Cookin

g: 

Once a cooking level has been set and the burner is in 

Programming Mode, the timer can be set to establish the automatic "off" time 
of the selected element.  To set a cook time, after programming the level of an 

element, touch the Timer key 

 ("00" will appear on the Timer display) and 

then select the desired cook time using the number keys. The programmed time