16
PUMP
UNIONS
PUMP
UNIONS
HEATER
UNIONS
DRAIN
PLUG
DRAIN
PLUG
2. The spa controller has an automatic one-hour “time-out” feature
should the high speed jet mode be left on inadvertently.
After one
hour of continuous operation, the controller will automatically
return to the maintenance/heating mode.
3. The spa controller also has a six-hour “time-out” feature should
the light be left on inadvertently.
After six hours of continuous
operation, the controller will automatically turn the light off.
PRIMING THE PUMP(S)
Upon filling or refilling the spa, if a pump is operating and water is not
flowing from any of its jets, the pump may not be properly primed.
To correct, refer to the illustration below and perform the following
procedures:
• Turn off power to the spa at the breaker and remove the equipment
compartment door.
• Loosen
the union on the top of the pump(s) to allow the air to
escape. When water is present, hand-tighten the union.
• Turn power back on, activate the pump and check to make sure
union is tight enough to keep it from leaking. Re-install equipment
door.
NOTE: Equipment compartment illustrated below will vary
depending on spa model.
IMPORTANT
THE DRAIN CAP AND UNION FITTINGS IN THE EQUIPMENT COMPARTMENT
MAY LOOSEN DURING TRANSPORTATION. TO AVOID LEAKS, PLEASE
CHECK TO MAKE SURE THESE ARE HAND-TIGHT
PRIOR TO FILLING YOUR SPA.
Getting Started
Summary of Contents for Aventine
Page 1: ...VACANZA SERIES 2 0 1 7 O W N E R S M A N U A L 5 0 H z...
Page 38: ......
Page 39: ......
