CalderaSpas CalderaSpas Utopia Series, Owner'S Manual

HYDRO JETS

ADAPTAFLO Jets -

 These jets allow you to redirect the jet stream by 

changing the position of the nozzle.

ADAPTASSAGE Jets -

 These jets provide a rotating massage pattern.

The face plates in the 

ADAPTAFLO

 jets and the 

ADAPTASSAGE

 jets 

are interchangeable. To remove a 

ADAPTASSAGE

 face plate, turn it 

counter-clockwise until it stops turning. Turn the face once more until 

you hear a clicking noise, push it in, and then pull it straight off.  Install 

the face plate by snapping it into place.  Additional 

ADAPTASSAGE

dual-port nozzles are available from your 

CALDERA

 dealer.

Both the 

ADAPTAFLO

 and 

ADAPTASSAGE

 jets allow you to regulate 

the force of the massage. Rotate the fascia ring to reduce or increase 

the force. Notice that turning off the flow to some jets increases the 

flow to the other jets. To avoid damage to your spa’s plumbing and 

components, do not turn off more than half of these jets at the same 

time.

Euro Directional -

 The Euro Directional jets, with eyeball nozzles, 

deliver a direct, more focused massage. 

EURO-PULSE Jets - 

The 

EURO-PULSE

 jets feature a special insert 

that creates a soft, pulsating, rotary massage. 

NOTE:

 Please do not attempt to rotate the jet face on either the Euro 

Directional, or EURO-PULSE as these jets do not regulate the force of 

the massage.

VERSASSAGE Jets -

 These jets may be adjusted to provide either a 

stationary, direct stream or, by positioning the nozzle to one side or the 

other, a rotating jet stream. 
The 

VERSASSAGE

 jets allow you to regulate the force of the massage. 

Rotate the fascia ring counter-clockwise to reduce the force, or 

clockwise to increase the force. Notice that turning off the flow to some 

jets increases the flow to the other jets. To avoid damage to your spa’s 

plumbing and components, do not turn off more than half of these jets at 

the same time.  For cleaning instructions, see the 

VERSASSAGE

 Jets 

Maintenance section.

ORBISSAGE Jets -

 This jet provides a unique, pulsating massage. 

The flow is adjustable in that it can be turned completely off or on 

(by rotating the jet faceplate). It is also interchangeable with the 

VERSASSAGE

 jet. For cleaning or replacement instructions see 

VERSASSAGE

 Jets in the Spa Care and Maintenance section. 

DIVERTER VALVES

The diverter valves on your spa allow you to direct the flow of water 

from the pumps to various combinations of jets. The functions of these 

diverter valves can best be learned by experimentation as follows:
Set all air controls to the “ON” position.
Turn on both pumps.
Turn the handle on 

each diverter valve and 

see which groups of 

jets are affected. (Note 

that you can adjust the 

diverter valves to any 

position between the 

two possible extremes to 

achieve the jet pressure 

that feels best to you.)

IMPORTANT: 

Your spa is not designed to provide full power to all jets 

when the diverter valves are in the “mid” position. However, with the 

diverter valve in this position, you may increase the power to selected 

jets by rotating the face of the 

ADAPTAFLO

 and 

ADAPTASSAGE

 jets 

to close the ones that are not in use.

TIP: 

Turn both pumps on and place the diverter valves to the “Mid-

Position”. Then experiment with each of the air controls to see their 

effect. 

Page 5

Getting Started

EURO-PULSE

 Jet

Euro Directional Jet

ADAPTAFLO

 Jet

ADAPTASSAGE

 Jet

VERSASSAGE

 Jet

ORBISSAGE

 Jet