45
MAIN CONTROL PANEL
Your spa comes equipped with a control panel located on the bartop above the equipment compartment door. The control panel allows the
user to set the temperature, activate the jets and lights, and access menus to lock the temperature and/or spa functions, and uses
indicator lights and an integrated LED display to provide a quick visual check of the spa's status.
MENU MODE
UP Button
MENU MODE
DOWN Button
OFF
DOWN Button
ON
UP Button
JETS Button
LIGHTS Button
PARADISE OPERATING INSTRUCTIONS
MAIN CONTROL PANEL BUTTONS AND DISPLAY
Your spa control system consists of an illuminated Light Emitting Diode (LED) and convenient push buttons that allow you to set the water temperature, as well as the
hydrotherapy jets, mood lighting, and optional jets from the spa control panel.
DISPLAY INVERSION
You may invert the control panel display for easier viewing from inside the hot tub.
To invert the display the following is required: Press the “MODE
” & “OFF
”
buttons simultaneously. By pressing the “MODE
” & “OFF
” buttons simultaneously
a second time the screen will go back to it’s original display.
TEMPERATURE CONTROL
The set temperature range is from 26°C (80°F) to 40°C (104°F). The set temperature of the spa water will automatically be 38°C (100°F) the first
time power is applied. This is the setting programmed at the factory. After the spa has been set up and used, the last temperature value set by the
user will be stored in memory. If power is disconnected from the spa, it will automatically revert to the last set temperature when power is reapplied.
(Temperatures of any setting may rise slightly depending on the current use and condition of your spa, and on outside temperature.)
To display the set temperature of the spa, press the “ON ▲” button. The set temperature will be displayed, unless the spa is locked (in which case the lock icon is
displayed). The set temperature display will automatically return to actual temperature after five seconds. To increase the set temperature of the spa water, press the
“ON ▲” button. Each time the button is pressed, the set temperature display will increment by 0.5º C. If the button is held down, the set temperature display will increase
by 0.5º C every half-second.
To decrease the set temperature of the spa water, press the “OFF ▼” button. Each time the button is pressed, the set temperature display will decrement by 0.5º C. If the
button is held down, the set temperature display will decrease by 0.5º C every half-second.
If the set temperature value will not change, check the TEMP LOCK and SPA LOCK features. When either of these features is applied, the temperature control is disabled.
Summary of Contents for CANTABRIA
Page 1: ...2 0 1 5 O W N E R S M A N U A L 5 0 H z...
Page 75: ......
