LIGHT CONTROL
The “LIGHT” button activates the light and controls the intensity. Pressing the “LIGHT” button operates the light as follows:
• 1st press of the “LIGHT” button – light will turn on to the maximum intensity.
• 2nd press of the “LIGHT” button – light will turn to medium intensity.
• 3rd press of the “LIGHT” button – light will turn to low intensity.
• 4th press of the “LIGHT” button – light will turn off.
If the light is left on, it will automatically turn off after 6 hours of continuous operation. The light symbol on the control panel will also turn off when the light is
deactivated.
If the light will not turn on, make sure SPA LOCK is deactivated. SPA LOCK disables the functions on the control panel.
LIGHT CONTROL (SPAGLO
®
LIGHTING SYSTEM - OPTIONAL)
If your spa is equipped with the optional SpaGlo lighting system, the spa and grab bar will change colors via a color wheel. The color wheel may be stopped on any
color. The following buttons must be pressed to start and stop the wheel:
Press the “SET” + “LIGHT” button simultaneously while the light is on to start or stop the color wheel. The light symbol will flash on and off when the color wheel is on,
and the light symbol will display continuously when the wheel is stopped.
The Automatic Light Feature allows you to set the SpaGlo lighting system to activate automatically. To activate, press and hold “TEMP
▲
” and “LIGHT” button
simultaneously at the desired time you want your spa light to come on. Setting feature at 7 pm. will turn on spa light at the same time every day. When activating
feature, the light symbol will flash twice confirming activation.
SUMMER MODE
Your Caldera
®
spa is equipped with a Summer Mode timer. The Summer Mode timer can be activated during extremely hot summer months if it
becomes difficult to maintain water temperatures low enough for comfort. Upon switching to the ON mode, the heater will immediately shut down
while the circulation pump (which can add heat to the water through normal operation) will remain on for approximately 5 minutes for heater cool-
down. Both heater and circulation pump will remain off for the next eight hours. Additionally, the summer mode display on the main control panel
will activate and remain active for as long as the summer mode is on. Following this eight hour period, the circulation pump, and heater will continue to turn off for an
eight hour period every day that the switch remains in the ON position. In this way, the amount of heat transferred to the spa water will be minimized. When the outside
temperatures begin to cool, the Summer Mode timer should be turned to the OFF position (the summer mode display on the main control panel shut off). This is the
efficient 24 hour circulation mode that keeps the heater operation and operating costs to a minimum during colder/heavier usage months.
NOTE
: Whenever power is disconnected and then reconnected to the spa, the Summer Mode timer will reset starting with the 8-hour shutdown mode. If a different 8-
hour shut down time is desired, deactivate the Summer Mode, then reactivate at the beginning of the desired 8-hour shut down time.
IMPORTANT
: The Summer Mode will not lower the spa’s waters temperature below the ambient air temperature.
To activate the Summer Mode, simply follow these steps:
1. Set the temperature control to 80°F (27°C)
2. On the control panel, simultaneously press and hold for 3 seconds “TEMP
▲
“ and “TEMP
▼
“ to activate the Summer Timer.
The Summer Mode must be deactivated when cooler temperatures return. To do this, simply repeat step 2.
WARNING:
Failure to deactivate the Summer Mode when the temperature drops below 32°F (0°C) will result in freezing of the spa. Damage resulting from this
situation is not covered under the terms of the warranty.
OPERATING INSTRUCTIONS
21
