Page 11
PARADISE SERIES
WARNING!
THE EXACT PHYSICAL LOCATION OF THE TERMINALS ON THE GFCI BREAKER
WILL VARY BETWEEN MANUFACTURERS. CONNECTING THE HOT WIRE TO THE
NEUTRAL TERMINAL WILL CAUSE IRREVERSIBLE DAMAGE TO THE CONTROL BOX.
** Refer to NEC 250-122 (table)
*PROVIDED WITH SPA.
NOTE: ALL WIRING SHOULD BE COPPER.
230 Volt Permanently Connected
** Refer to NEC 250-122 (table)
NOTE: The wire connections to GFCI breakers are for reference only. Always ensure the white neutral wire is connected to the load neutral of the 30 amp breaker.
Strip wire
insulation back
½”
Entire stripped
end of wire
must be inside
Terminal
Block
After step 6,
pull on wire to
ensure proper
installation
Remove
screwdriver
Install
Stripped end
of wire into
Terminal
Block
Push top of
screwdriver away
from wire
Terminal
Block
Insert
screwdriver to
engage cage
clamp
4
6
1/2”
3
5
3
WIRE INSTALLATION
FOR CONTROL BOX TERMINAL BLOCK
(Layout of Spa’s Terminal Blocks may vary)
Wire Installation Steps
Refer to spa’s wiring
diagram on back of Control
Box Cover for proper wiring
and jumper configuration!
(1 cm)
(1 cm)
