5
V i s i t u s o n l i n e a t
c a l i f o n e. c o m
V i s i t u s o n l i n e a t
c a l i f o n e. c o m
Getting Started
The LED display will be in red (for standby mode) when the ‘Power’ button is pushed. Pushing the LED will cause the LED to
be green indicating the unit is fully powered up.
• Depressing the ‘Tape’ button will cause the LCD display to show ‘Tape’.
• Depressing the ‘AM/FM’ button will cause the LCD display to show ‘AM’ or ‘FM’.
• Depressing the ‘CD’ button will cause the LCD display to show ‘Disc’.
Digital Volume Control
• The volume control is preset to automatically turn on at volume level “26” upon
power up. Press ‘VOL
q
’ to reduce the volume, the level will be shown in the LCD
panel. Minimum volume will show ‘00’ on the LCD display.
• Press ‘VOL
p
’ to increase the volume. The maximum volume is ‘40’ on the LCD display.
Treble and Bass Controls
‘TREBLE
p
’ and ‘TREBLE
q
’ can be used to adjust the Treble up and down respectively,
while ‘BASS
p
’ and ‘BASS
q
’ can be used to adjust the Bass up and down respectively.
Both Treble and Bass can be adjusted in the range of +5 to –5.
PLL Radio Function
• Press ‘AM/FM’ to select the desired reception band. Extend the telescoping
antenna for FM. There is a built-in antenna for AM reception. For FM stereo
reception the ‘stereo’ will show on the LCD display.
• Press the ‘TUNER
p
’ or ‘TUNER
q
’ button repeatedly until the desired station
shows on the LCD display.
• To automatically scan through the frequency bands, hold the ‘TUNER’ button
down until you see the speed of the LCD display increase. Scanning will stop
when a strong signal is detected.
Getting Started
continued
VOL 26
VOLUME
Electronic Volume Control Display
TRE+2
Treble
BA+1
Bass
520
AM
KHz
AM Band Selection
