background image

Wireless Operation

Feedback is a shrill screeching sound produced by the speaker system when a microphone is being used too close to the 

front of the speaker. The microphone picks up the sound of the speaker system and it becomes reamplified. It is a self-

sustaining loop which can damage the system if allowed to continue, not to mention the annoyance caused to persons 

nearby. Always stand 4 to 6 feet from the speaker to minimize the opportunity for feedback from the speaker system.

Wireless UHF Receivers 

Wireless  receiver “A”  is  preset  at  the  factory  for  channel  4  and 

receiver “B” is set on channel 6. There are three (3) LEDs on the 

receiver; power (green), RF reception (red) and Audio reception 

(amber).

There are also LEDs on the front of the speaker above the grille 

making it easy to see if the microphone and receiver are work-

ing properly. A red LED indicates RF (radio frequency) from the 

microphone, while an amber LED indicates audio.

Wireless Transmitter

The PowerPro PA919 incorporates a 16 channel UHF transmitter with its own power switch for wireless transmission to 

the Powered Companion Speakers PA919PS. The transmitter is preset at the factory to channel 13. It is  recommended 

that the user not randomly change this setting. If using the transmitter function change wireless receiver “A” from channel 

1 to any other channel except channel 13 to prevent the transmitter from blocking the receiver.

Microphone Lockout

Two wireless microphones can be used at the same time, but separate channels (frequencies) must be used. For instance, 

if using receiver “A” on channel 4, two microphone beltpack transmitters cannot be used at the same time. The first 

transmitter turned on will dominate and lock out the other. The second microphone should be used with receiver “B” on 

a different frequency which will allow two persons to talk at the same time.

Turn the transmitter power switch to OFF when not being used to minimize battery drain. 

5

6

UHF FULL DIVERSITY

Microphones & Belt-Pack Transmitter

16-Channel UHF Transmitter

Selector Buttons

Q319 Wireless Microphone

Volume 

Control

Battery

Compartment

Power On 

Switch

16-Channel UHF Transmitter

Selector Buttons

M319 Wireless Belt Pack Transmitter

OE-316 

Over Ear Mic

NM-316 

Neck Mic

LM-316 

Lapel Mic

CM-316 

Collar Mic

HBM-316 

Headset Mic

 The M319 

is used with these 

5 microphones

califone_919_manual_rev1.indd   8-9

6/22/09   1:16 PM

Summary of Contents for PowerPro PA916-SP









Reviews: