califone.com
8
4.6 AUTO CHANNEL SELECTION (WS-T & WS-R)
1. First, power on all of the WS-T and WS-R beltpacks to be set on
the same channel. Use the power on procedure in section 4.4.
2. For the WS-T, ensure that the channel you want to use is not
already in use and that the frequency is clear of any interference.
3. Change the channel of the WS-T transmitter to the desired
channel using the procedure in section 4.5.
4. To automatically connect each WS-R receiver to the same
channel as the WS-T, follow this procedure for each WS-R:
5. Ensure that the “CHANNEL LOCK” switch on the back of the unit
is switched to OFF.
6. Position the WS-R within one foot of the WS-T transmitter to
connect to.
7. Simultaneously press the CHANNEL UP and
CHANNEL DOWN buttons and hold for > 3
seconds. The WS-R will now search for the
transmitter.
8. Once successfully connected to the transmitter channel, the LCD
will stop flashing. The channel should now be set to the same
one as the WS-T.
9. Continue this process until all WS-R beltpacks have been set to
the WS-T channel.
4.7 CONNECTING TO THE AUDIO INPUTS (
WS-T)
1. To transmit audio from a microphone, connect the 3.5mm plug of
the electret microphone into the mic jack.
2. To transmit audio from the line/headphone output from a media
player/computer/etc. connect a 3.5mm adapter cable from the
line output of the device to the line input jack on the WS-T.
4.8
CONNECTING HEADPHONES (WS-R)
1. Up to two headphones can be connected to each WS-R
beltpack.
2. Use the VOLUME UP/DOWN buttons to adjust the volume to
the desired level. Both headphone outputs are affected by the
volume control.
4.9 SETTING VOLUME (
WS-T & WS-R)
NOTE: Tapping the volume button will change the volume
incrementally, while holding down the button will result in a
continuous increase or decrease.
1. Increase the volume on the WS-T.
