10
Customer Support: 1-866-409-4581
AIR COMPRESSOR
Test Run
Before using the air compressor for the first time, complete a test
run as follows:
1.
Turn the power switch to the OFF position. Plug the power
supply cord into a power supply socket. Start the air
compressor by turning the power switch to the ON position.
The pressure gauge reading will slowly rise as pressure
increases inside the air tank. When the gauge reading reaches
120 -125 PSI, the pressure switch will automatically turn the
power off. This indicates the compressor is working normally.
2.
Daily Operation
Starting the compressor:
1.
Turn the power switch to the OFF position.
2.
Attach the air hose or air fitting to the Female 1/2” NPT port
located on the right end of the air compressor air tank.
3.
Close the manual drain valve.
4.
Plug the power supply cord into a power supply socket.
5.
Turn the power switch to the ON position.
6.
Let the motor run and tank fill until motor turns off.
7.
Operate air tool normally.
8.
To regulate the air to the air hose. have the air compressor
and air tool both turned on and running. Turn the regulator
knob to the right to increase the pressure and to left to
decrease the air pressure to the hose and air tool..
Do not use continously (running) for more than (1) hour.
Shutting down the compressor:
1.
Turn the power switch to the OFF position.
2.
Unplug the power supply cord.
3.
Reduce the pressure in the air tank through the air hose.
4.
Draining the air tank regulatorly from the manual drain valve
will help prevent corrosion in the air tank.
Air compressor surfaces become hot during
operation.
DO NOT touch hot surfaces, because they can cause
severe burns.
Do not touch the air compressor’s cylinder head.
During operation, the cooling fins of the cylinder
head and delivery pipe become hot.
Allow the air compressor to cool before touching it.
DO NOT place a storage cover on the unit during
operation. Only place a cover on the air compressor
after it has thoroughly cooled down.
FIRE
HOT SURFACE
WARNING
Flying objects can cause injury to the eyes, head and
other parts of the body.
Air-powered equipment and power tools are capable
of propelling items (metal chips, fasteners and
particulates) at high speed into the air and could
result in injury.
Always wear approved head and eye protection.
Never point the air stream at any part of your body,
or at another person or animal.
When operating the air compressor, make sure all
other people and animals maintain a safe distance.
Do not move the air compressor when the air tank is
under pressure.
Never use the air hoses to pull or move the air
compressor.
Keep the air compressor on a flat surface.
WARNING
FLYING OBJECTS
Note:
If the Air Compressor is not working properly, the
pressure gauge will indicate that there is a decrease in
pressure in the air tank. If there is an air leak from the
compressor the pressure in the air tank decreases, the
pressure switch resets and the motor automatically turns
back on.
If you detect an air leakage, turn the power switch to the
Off position, release the air from the tank by pulling on
the safety valve. Unplug the power supply cord and contact
Customer Support for Assistance.
Turn the power switch to the Off position, unplug the power
supply cord and release the air from the manual drain valve.
At this point proceed to the next step (daily operations)
starting the air compressor to continue to use.
