11
Customer Support: 1-866-409-4581
AIR COMPRESSOR
Test Run
Before using the air compressor for the first time, complete a test
run as follows:
1.
Turn the power switch to the OFF position. Plug the power
supply cord into a power supply socket. Start the air
compressor by turning the power switch to the ON position.
The pressure gauge reading will slowly rise as pressure
increases inside the air tank. When the gauge reading reaches
115 PSI - 120 PSI, the pressure switch will automatically turn
the power off. This indicates the compressor is working
normally.
2.
Daily Operation
Starting the compressor:
1.
Turn the power switch to the OFF position.
2.
Attach the air hose to the 1/4” quick connect coupler
3.
Close the drain valve.
4. Have air filter attached
5.
Plug the power supply cord into a power supply socket.
6.
Turn the power switch to the ON position.
7.
Let the motor run and tank fill until motor turns off.
8.
To regulate the air flow.
While the air compressor is running, turn “On” your tool and
turn the regulator knob to the right increasing the pressure.
Turn the pressure up until the desired pressure is reached.
9.
Operate air tool normally.
Shutting down the compressor:
1.
Turn the power switch to the OFF position.
2.
Unplug the power supply cord.
3.
Reduce the pressure in the air tank through the air supply
hose.
Note:
If the Air Compressor is not working properly, the
pressure gauge will indicate that there is a decrease in
pressure in the air tank. If there is an air leak from the
compressor the pressure in the air tank decreases, the
pressure switch resets and the motor automatically turns
back on.
If you detect an air leakage, turn the power switch to the
Off position, release the air from the tank by pulling on
the safety valve. Unplug the power supply cord and contact
Customer Support for Assistance.
Turn the power switch to the Off position, unplug the power
supply cord and release the air in the tank by pulling on the
safety valve. At this point proceed to the next step (daily
operations).
