10
Customer Support: 1-866-409-4581
AIR COMPREssOR
OPeRATING THe AIR
COMPReSSOR
.
Test run
before using the air compressor for the first time, complete a test
run as follows:
Plug the power cord from the air compressor into the Power Foot
Pedal cord socket.
Plug this cord into a power supply such as a (wall socket).
Open the Air Hose outlet (air cock) by tuning the level to the
forward or middle position.This will open the outlet and release
the air.
Start the air compressor by pressing down on the Power Foot
Pedal.
The motor will start running.
Air will be released from Air Hose outlet (air cock) and the bottom
of the water trap (bleeder Valve).
This indicates that your air compressor is working normally.
Important!
If the Air Hose outlet (air cock) and bleeder Valve (bottom of the
Water Trap) are closed, the motor
Will not operate!
For the motor to work normally, air must be released from the
motor/pump at all times.
Air must be released from the air hose, air cock (hose outlet) or
bleeder valve.
If air is not released from the pump, the pump is fully pressurized.
When the pump is fully pressurized the motor cannot turn and
operate / run normally..
For best operation, open the bleeder valve located at the bottom
of the water.
This will allow air out continously and allow the air compressor
operate normally.
daily operation
Starting the compressor:
1.
Attach the air hose to the air compressor
Lift up and turn the regulator knob completely to the left.
This will turn down the pressure at the air hose before starting
.
3.
Plug the power supply cord into a power supply socket
and press down on the Power Foot Pedal.
4.
Let the motor run and turn the regulator knob to the right
increasing the pressure to the desired pressure needed..
(Note) The pressure can be adjusted that the bottom of
the water trap by turn the valve open letting air out.
5.
Operate air tool normally.
6.
Only operate continously for 1 hour maximum.
Allow compressor to cool down before restarting
Shutting down the compressor:
1.
Release the pressure from the Power Foot Pedal.
2.
unplug the power supply cord.
10