INSTRUCTIONAL MANUAL
2750L-P/4500L-P/6000L-P
August, 2001
Rev. K
-45-
3.
Depress the MNU key several times until the configuration menu screen is displayed as illustrated
below:
CFG
=
16
ALM
=
17
FLM = 18
CLM = 19
To program the default frequency, enter the key sequence:
1
8
ENT
A
next enter the default frequency followed by depressing the PRG and ENT key.
To program the default voltage range, perform step 1 through 3. Next enter the key sequence:
1
7
ENT
A
At this point, if 0 is entered, the default voltage range is the Low Range.
If an 8 is entered, the default voltage range will the High Range.
To make the High Range the default, continue the key sequence with:
8
PRG
ENT
To program the default voltage, perform steps 1 through 3. Next enter the key sequence:
2
9
ENT
A
At this point the default voltage from 0 to 5 may be entered. If a value of less than 5 volts is
entered, the output may fault when a voltage is programmed to a value that is less than 50%
of full scale.
To make 5 volts the default voltage, continue the key sequence with:
5
PRG ENT
To program the default current limit, perform steps 1 through 3. Next enter the key sequence:
2
9
ENT
C
At this point, any value may be entered up to the maximum current available per phase.
To make 5 amps the default value, continue the key sequence with:
5
PRG
ENT
3.5.17
TO PROGRAM 1 OR 3 PHASE MODE (MOD=30) (MOD Option)
The MOD selection is an option for the AC Power System. When the option is installed, the AC Power System may be
programmed to either be a 1-phase or a 3-phase power system.
The MOD screen displays the output configuration of the power system, 1-phase (PHS1) or 3-phase (PHS3).
To program the power system to the 3-phase output mode, enter the following key sequences:
Summary of Contents for 2750L-P Series
Page 119: ...INSTRUCTIONAL MANUAL 2750L P 4500L P 6000L P August 2001 Rev K 115 Figure 6 1 MODULE LOCATION...
Page 138: ...INSTRUCTIONAL MANUAL 2750L P 4500L P 6000L P August 2001 Rev K 134 Figure 14 EMERGENCY VOLTAGE...
Page 148: ...INSTRUCTIONAL MANUAL 2750L P 4500L P 6000L P August 2001 Rev K 144 FIGURE 2...
