California Trimmer Mower
Maintenance Manual
38
Heavy Duty & Commercial
Drive Shaft Assembly – (Continued)
Step 8
Install the second small hard washer, steady rest, sprocket and set collar, as shown, on the other side of
the shaft. Put the rounded edge of the hard washer towards the steady rest. Leave the two (2) set
screws on the sprocket loose in order to align the sprocket with the roller sprocket after the drive shaft
assembly has been installed in the mower.
Leave the two (2) set screws on the set collar loose until after the wheels have been installed.
Install the steady rest as shown (grease zerk facing down)
Step 9
Install the first wheel on this side with the zerk fitting facing the spring. Install as many wheel spacers or
shims as you did during the installation of the first set of wheels on the other side to ensure even
placement of the wheels.
Install the second wheel with the zerk fitting facing the end of the drive shaft. Install the second bearing
and holder with a driver as before, making sure not to damage the bearing.
Step 10
Grease the remaining three (3) wheels and steady rest.
