California Trimmer Mower
Maintenance Manual
39
Heavy Duty & Commercial
Drive Shaft Assembly – (Continued)
Step 11
Install the assembled drive shaft into the mower frame.
Bolt the bearing holder to the frame, on the left-side, or the clutch side of the drive shaft.
Bolt the bearing holder to the frame on the other side.
Tap the end of the drive shaft to ensure it is seated completely in the left-side bearing holder.
Slide both wheels and set collar over, against the bearing holder and tighten the two (2) set screws.
Align the roller drive sprocket with the roller sprocket and tighten the two (2) set screws,
be sure that one
of the set screws is tightening on the flat surface on the drive shaft
. Install the roller chain and
roller springs.
Install the 17 tooth sprocket and tighten the two (2) set screws,
be sure that one of the set screws is
tightening into the dimple on the drive shaft.
Install chain and chain guard.
Install the engine chain and chain guard.
Install the two (2) clutch forks and clutch adjustment bolt.
Attach the clutch rod to the clutch fork.
Adjust the clutch. (See Clutch Adjustment on Page 28)
